AI summary by TwinMind
How Do Nuclear Submarines Make Oxygen?- Smarter Every Day 251
SmarterEveryDay
29m 33s
Central Atmospheric Monitoring System (CAMS)
- Located middle of boat, monitors oxygen/carbon dioxide levels throughout submarine
- Monitors good gases (O2) and bad gases (CO, R114 refrigerant, hydrogen, nitrogen, water)
- Shows total pressure per compartment with sampling panel index
- Dial system allows monitoring different stations/compartments
- Alarm system triggers for high/low oxygen or dangerous gas levels
- Uses "sniffers" (universal refrigerant leak detectors) to locate specific leaks
- Sound like Geiger counter when detecting leaks
- Adjustable sensitivity: small/medium/large leak settings
- Trigger kit with tubes tests air samples for various gases
- pH.D6 device measures lower explosive limit for hydrogen
Oxygen Generation Method 1: Electrolysis
- Initial concept: use seawater + nuclear reactor power for electrolysis
- Would create chlorine gas + hydrogen (deadly to crew)
- Seawater electrolysis liberates chlorine, not oxygen
- Actual process: purified water through reverse osmosis filtration
- Uses potassium hydroxide (KOH) as catalyst/electrolyte
- AOG (Automated Electrolytic Oxygen Generator) near nuclear reactor
- Process: H2O splits into hydrogen + oxygen
- Oxygen used for breathing
- Hydrogen vented overboard
- Requires electrical power from nuclear reactor
Oxygen Generation Method 2: Oxygen Candles
- Backup method when AOG system down
- Contains iron + sodium chlorate chemicals
- Ignition via red phosphorus striker (9-inch nail with phosphorus tip)
- Burns 45 minutes to 1 hour per candle
- Two candles burned simultaneously (90 minutes to 2 hours total)
- Burns at ~1500 BTUs, extremely hot temperature
- Class Delta fire (self-oxidizing, cannot be extinguished)
- Chemical process:
- Iron burning creates iron oxide + heat
- Heat liberates oxygen from sodium chlorate
- Net result: more oxygen produced than consumed
- No electricity required - works during power outages
- Byproducts called "clinkers" after burning
- Used every 2 hours alternating between forward/engine room compartments
CO2 Scrubbing Method 1: Monoethanol Amine (MEA)
- Two Mk Bravo CO2 scrubbers processing ~370 cubic feet/minute
- Uses monoethanol amine (MEA/amine) liquid chemical
- Two-stage process:
- Absorber tower: lean amine sprayed over CO2-laden air
- Increases surface area for CO2 absorption
- Creates "rich amine" (CO2 saturated like fizzy drink)
- Boiler stripper: rich amine heated under pressure
- Higher pressure increases boiling temperature
- Heat boils off CO2, creating "lean amine" (flat like flat Coke)
- Absorber tower: lean amine sprayed over CO2-laden air
- CO2 compressed to sea water depth pressure, vented overboard as fine bubbles
- Preheating function between absorber tower and boiler stripper
- Continuous recyclable process - no consumables required
- Amine smell notorious among submarine spouses on clothes
CO2 Scrubbing Method 2: Lithium Hydroxide
- Backup/emergency CO2 scrubbing method
- Square canisters (reference to Apollo 13 incident)
- Passive chemical absorption - no power required
- Can be sprinkled on bunks if power fails
- Used in Navy SEAL rebreathers and astronaut EVA suits
- Works by exposing lithium hydroxide to air for CO2 absorption
Atmospheric Management Integration
- Continuous monitoring via CAMS system
- Personnel monitor oxygen levels, make recommendations to burn candles
- Chief of watch approves candle burning decisions
- Oxygen levels rise 3-4 points over hour from candle burning
- Balance between oxygen generation and crew consumption
- Maintaining suitable atmosphere rather than increasing levels
