AI summary by TwinMind
How Dry Erase Boards Are Made | How It’s Made
Science Channel
5m 10s
Introduction and Basic Functionality
- Dry erase board = non-permanent surface for professional/classroom use
- Also known as whiteboards
- Write with dry erase markers, wipe with specialized cloth
- Clean surface due to non-porous material + dry erase ink contains release agents preventing permanent pigment adhesion
Board Types and Materials
- Green/black boards: can double as chalk boards
- Gray/low gloss white: double as projection boards
- Surface material: porcelain coated steel sheet
- Flexible enough to roll up
- Pressure-sensitive
- Seven substrate types available: cardboard to medium density fiberboard (MDF)
Manufacturing Process - Surface Material Preparation
- Roll mounted on cutting machine
- Technician programs machine to cut specific length based on board dimensions
- Workers verify length and check piece is square
- Surface material applied to chosen substrate type
Substrate Cutting and Preparation
- Large MDF sheet cut into board-sized pieces
- Technician enters length/width into cutting machine
- Machine ejects substrate cut to exact board size
Adhesive Application and Foil Backing
- Substrate put through hot glue machine
- Polyurethane adhesive applied to back of dry erase board
- Foil sheet applied to glued surface
- Prevents moisture entry that would warp substrate
- Board moves through two steel rollers
- Flattens foil
- Presses out trapped air
Surface Material Application
- Craftswoman uses air hose to clear dust from board side
- Board goes through glue machine
- Porcelain steel sheet placed on glued surface
- Technicians avoid touching pressure-sensitive surface with fingers
- Board moves through steel rollers to press porcelain steel flat and remove trapped air
Curing Process
- 50 boards stacked together
- Put in press for 30 minutes until glue cures
Frame Manufacturing
- Machine cuts material for board frame
- Punches V-shaped notches in aluminum trim lengths
- Trim bends at each notch to form wraparound frame
Marker Tray Production
- Board-length pieces cut from L-shaped metal trim
- Sharp tray ends covered with plastic end covers
- Secured with screws on both ends
Final Assembly
- Technicians peel off protective film from writing surface
- Board flipped over for back assembly
- Two frame options:
- Traditional wraparound frame
- Four straight C-shaped pieces fitting over board edges
- Screws attached through trim into substrate for stability
- Completed board placed in box for shipping
Distribution
- Ready for shipment to businesses or classrooms
