AI summary by TwinMind
Lecture 2: Analysis Methods and Rectifiers
MIT OpenCourseWare
50m 48s
Linear vs Switching Power Supplies Review
- Linear power supply: variable resistor approach with feedback control
- Voltage drop VD across pass transistor
- Power dissipation = VD × I (not zero on average)
- Inefficient, especially with large conversion ratios
- Switching power supply concept:
- Uses semiconductor switches (Q(t) = 1 or 0)
- Pulse width modulation with duty ratio D
- LC filter extracts DC component
- Vout ≈ D × VIN
- Theoretical efficiency approaches 100%
- Switches, inductors, capacitors ideally lossless
Time Domain Analysis Approach
- Circuits tend to be nonlinear or time varying
- Time domain analysis preferred over frequency domain
- Two key concepts introduced:
- Method of Assumed States (MAS)
- Periodic Steady State (PSS) analysis
Ideal Diode Characteristics
- Simplified switch model for analysis
- On state: VD = 0, ID > 0 (short circuit)
- Off state: VD < 0, ID = 0 (open circuit)
- Cannot support:
- Negative current
- Positive voltage
- Uncontrolled switch - external circuit determines state
Method of Assumed States (MAS)
- Step 1: Assume state for each switch (on/off)
- Step 2: Substitute short circuit (on) or open circuit (off)
- Step 3: Analyze voltages and currents in resulting linear circuit
- Step 4: Check if switch conditions are violated
- If assumed on: check if current went negative
- If assumed off: check if voltage went positive
- Step 5: If violated, make new assumptions and iterate
- Step 6: If not violated, continue analysis
Simple Rectifier Circuit Analysis
- Circuit: VS sin(ωt) → diode → resistor R
- Analysis shows diode on when VS sin(ωt) > 0
- Diode off when VS sin(ωt) < 0
- Output: half-wave rectified waveform
- Vout follows input during positive half-cycle, zero during negative
Periodic Steady State (PSS) Concept
- Operating regime where circuit repeats every cycle
- All waveforms identical from cycle to cycle
- State variables return to same values at cycle boundaries
- Similar to sinusoidal steady state but for non-sinusoidal waveforms
- Key property: average inductor voltage = 0 in PSS
- Key property: average capacitor current = 0 in PSS
Inductor-Filtered Rectifier Analysis
- Added inductor to smooth output current
- Initial assumption: diode always on
- KVL analysis: VS sin(ωt) - VL - Vout = 0
- Taking average: 0 - 0 - Vout_avg = 0 → Vout_avg = 0
- Contradiction indicates assumption violated
- Problem: inductor forces diode to conduct during negative half-cycle
- Results in negative voltage portion until inductor voltage averages zero
Full-Wave Rectifier Solution
- Added second diode (D2) to provide current path
- D1 conducts during positive half-cycle
- D2 conducts during negative half-cycle (freewheeling)
- VX waveform: positive half-cycle of sine wave, zero during negative
- Average value: VX_avg = VS/π
- Output voltage: Vout ≈ VS/π (with large inductor)
- Achieves DC output with smooth current
Simulation Results
- LTSpice simulation confirms theoretical analysis
- Shows startup transient before reaching PSS
- In PSS: inductor current nearly constant, output voltage ≈ VS/π
- Demonstrates practical application of PSS analysis concepts
